18" Nylon Epoxy Roller, Lint-free Roller Cover for Epoxy Floors

This 18" nylon epoxy roller is a lint-free roller cover for epoxy floors and other high-viscosity coatings, available in 5 mm, 10 mm, 13 mm and 15 mm nap. The nylon fabric holds up to thick, solvent-bearing and two-part materials and releases them without shedding fibres into the finish, which matters on a clear or high-gloss floor.

On a floor coating job it is typically used to roll out or back-roll epoxy after it has been spread, leaving an even film. Mount it on an 18" roller frame with an extension pole, and load it from a tray or bucket wide enough for an 18" cover. It is recommended for smooth and semi-smooth surfaces.

• 18" nylon roller cover, lint-free
• Nap: 5 mm, 10 mm, 13 mm or 15 mm
• For epoxy coatings, rust paints, high-viscosity paints and two-part paints
• Also for stone and marble sealers, urethanes and fibreglass resins
• Made in Canada

Choosing a nap

• 5 mm: thin coats on smooth concrete and sealers
• 10 mm and 13 mm: general epoxy work and moderate film builds
• 15 mm: carries the most material per load, for heavier coats or a little more surface texture