Guide
Spiked Shoes for Epoxy: Sizing, Walking and Spike Care
Spiked shoes let you walk back into a wet floor to roll, broadcast or fix a spot without leaving a mark. Here is how to fit them, walk in them and keep them working.
· 3 min read

Epoxy spiked shoes let you walk back onto a wet self leveling or body coat to back roll, spike roll out air, broadcast flake, work a metallic effect or fix a problem in the middle of the room. You stand on the spike tips instead of a flat sole, and the coating flows back into the holes behind you.
1. Pick the size for what you wear underneath
Grimaldi Sharp Nail spiked shoes are resin overshoes with adjustable straps. They strap on over your own footwear, so choose the size by the boot you will wear on the job, not your shoe size on paper. They come in medium, large and extra large; see all spiked shoes.
Try them on with your work boots before the job. A strap that slips halfway across a wet floor is a problem you cannot fix where you stand.
2. Check the spikes against your coat
Each shoe uses replaceable 2 cm sharp nail spikes. That is enough to stand clear of a body coat or a self leveling pour. Check the film thickness on your coating's data sheet: the notch on your squeegee tells you roughly how deep the wet coat will be, for example the 15 to 20 mil squeegee for a standard body coat or the 25 to 30 mil squeegee for a heavier broadcast coat. For which blade suits which coat, see flat or notched squeegee.
Before you step onto the floor, check every spike is tight. A loose spike left in a fresh coat is a repair.
3. How to walk on wet epoxy: flat and straight
Step down flat so all the spikes go in together.
Lift your foot straight up. Do not drag or twist on the spot.
Take short steps and plan your route so you finish at the exit.
Keep your weight centred when rolling or broadcasting so you do not rock onto the edge of the shoe.
The coating should close over the spike holes on its own. If it does not, the coat is already past the point where you should be walking on it.
4. Know when to stay off
Spiked shoes are for wet coatings. Once a coat starts to set and turns tacky, spikes can leave marks that will not level out. Your coating's data sheet gives its working time; plan the walk in jobs, such as broadcasting flake, inside it.
5. Clean and replace the spikes
Clean the spikes before the resin cures on them, using the cleaner your coating's safety data sheet allows. Cured resin on a spike makes the next floor harder to walk.
Spikes wear and bend over time. The replacement spike set has 32 spikes and comes with nuts and spacers, so you can rebuild a pair instead of buying new shoes.
For the full order of work on a squeegee applied coat, see laying an epoxy body coat with a notched squeegee.
Questions contractors ask
What size spiked shoes should I buy?
Size them by the boot you will wear on the job, not your shoe size on paper. They strap on over your footwear and come in medium, large and extra large.
How long are the spikes?
Each shoe uses replaceable 2 cm sharp nail spikes, enough to stand clear of a body coat or a self leveling pour.
When should I stay off the floor?
Once the coat starts to set and turns tacky. Spikes can then leave marks that will not level out.








