Guide
Grinding Concrete with an Angle Grinder: A Safe Setup Checklist
A cup wheel spinning at 12,000 RPM deserves two minutes of checks before it touches the slab. Here is the setup, in order.
· 3 min read

Grinding concrete with an angle grinder and a diamond cup wheel is fast, and it is a fast way to get hurt if the setup is wrong. This angle grinder safety checklist takes a couple of minutes. Run it every time you change a wheel.
1. Match the wheel to the grinder's speed
Every cup wheel has a maximum speed. The grinder's no load speed must not be higher.
Grimaldi 5" Reaper cups, such as the 5" medium bond, are rated to 12,000 RPM.
Grimaldi 7" Reaper cups, such as the 7" medium bond, are rated to 8,000 RPM.
Check the plate on the grinder. A 7" wheel on a small, fast grinder built for 5" wheels is a common and dangerous mistake.
2. Check the arbor
Grimaldi cup wheels have a 5/8-11 threaded arbor. Thread the wheel onto the spindle by hand until it seats flat against the flange. Do not force a wheel onto a spindle it does not match.
3. Inspect the wheel
Before you mount it, look for cracked, loose or missing segments and a bent or damaged body. Do not use a wheel that has been dropped hard until you have checked it. A damaged wheel can throw a segment.
4. Fit the guard and a dust shroud
Use the guard made for the wheel and keep it in place. For concrete, fit a dust shroud sized for the wheel and connect it to an industrial extractor, such as one from the Grimaldi extractor line. Never remove the guard to reach an edge; use the right shroud for edge work instead.
5. Connect extraction and check the circuit
Plug in the extractor first and check the airflow at the shroud. If it feels weak, run through why a dust extractor loses suction. Make sure the grinder and extractor together will not trip the circuit: a 16 A extractor on a shared 15 A circuit will. The GX300 draws 14 A on 110 V; the CSX2V3 draws 16 A. See how to size a dust extractor.
6. Wear the right PPE for concrete dust
A fitted respirator suitable for silica dust (see silica dust when grinding concrete in BC)
Eye and face protection
Hearing protection
Gloves and sturdy footwear
Clothing that will not catch in the wheel
7. Test run before you grind
Stand to the side, out of line with the wheel, and run the grinder at full speed for a short while before it touches the floor. Stop if you hear rattling or feel vibration, and check the wheel and mounting again.
8. Grind with control
Hold the grinder with both hands, using the side handle.
Keep the wheel flat on the surface and let it do the work.
Move steadily; do not dwell in one spot.
Let the wheel stop completely before you put the grinder down.
Picking the right wheel for the slab matters as much as the setup. See how to choose a diamond cup wheel or browse the diamond cup wheels, and for stripping old coatings, how to remove an old floor coating.
Questions contractors ask
What RPM are Grimaldi Reaper cup wheels rated for?
The 5" Reaper cups are rated to 12,000 RPM and the 7" Reaper cups to 8,000 RPM. The grinder's no load speed must not be higher than the wheel's rating.
Can I put a 7" cup wheel on a grinder built for 5" wheels?
No. A 7" wheel on a small, fast grinder built for 5" wheels is a common and dangerous mistake. Check the plate on the grinder first.
What arbor thread do Grimaldi cup wheels use?
A 5/8-11 threaded arbor. Thread the wheel on by hand until it seats flat against the flange.








