Guide
Concrete Dust Extractor Losing Suction? A Five Minute Checklist
When dust starts escaping the shroud, the cause is almost always one of five things. Work through them in order before you call it a breakdown.
· 3 min read

A concrete dust extractor losing suction rarely dies all at once. Suction fades over a few hours until dust starts escaping around the shroud. Before you assume the motor is going, check these five things in order. Most take less than a minute.
Switch the machine off and unplug it before you open anything.
1. The filter is loaded
This is the most common cause. Concrete dust is fine enough to pack into a filter's surface and choke the airflow.
Run the machine's filter cleaning. Depending on the model, Grimaldi extractors shake the filter, backflush it or pulse it with air.
If suction does not come back after cleaning, the filter is worn out. Fit a new cartridge.
Every model has its own cartridge: CSX2V3, GX300, VC-3M, and the turbine filters for the JTXP110 and JTXP220. Keep a spare on the truck. The machines themselves are covered in Grimaldi concrete dust extractors, 220 to 420 CFM.
2. The bag or tank is full
A full bag backs up into the filter and the airflow drops off fast. On bag collection machines, change it before it is packed tight. The GRV-1050 collection bag comes as a 20 m roll, four rolls a box, so you can cut and seal a fresh length on site.
3. The hose is blocked or kinked
Disconnect the hose and look through it. A chunk of coating or a wad of debris can lodge at a bend or a coupling.
Check for kinks under pallets, doors and the grinder itself.
Check the cuffs at both ends for cracks. A split cuff leaks air before it reaches the shroud.
A long hose also costs airflow. Use the shortest run that reaches the work.
4. The wand or floor tool is worn
On clean up, a worn floor nozzle lets air in around the edges instead of pulling from the floor. Check the brushes or skirts and the wheels. The metal extension wand and wheeled floor tool are sold as wear parts so you can swap them out.
5. The filter is damaged or seated wrong
If dust is coming out of the exhaust, stop. A torn filter or one that is not sealed in its housing lets silica dust straight through the machine (see silica dust when grinding concrete in BC). Never run an extractor with a damaged or missing filter. Replace it and check the seal before you start again.
Still losing suction after all five checks?
If all five check out and suction is still down, note what you see and hear (motor sound, any burning smell, which model) and contact us. Do not keep running a machine that smells hot.
To make sure the extractor was right for the job in the first place, see how to size a dust extractor for your grinder, or browse vacuums and dust extraction.
Questions contractors ask
Why does my dust extractor lose suction?
Almost always one of five things: a loaded filter, a full bag or tank, a blocked or kinked hose, a worn wand or floor tool, or a damaged or badly seated filter.
When should I replace the filter?
When running the machine's filter cleaning does not bring suction back, or straight away if the filter is torn or dust comes out of the exhaust.
Dust is coming out of the exhaust. What now?
Stop. A torn filter or one not sealed in its housing lets silica dust through the machine. Replace it and check the seal before you start again.










