Guide
Flat or Notched Squeegee? Which to Use for Each Coat
A notched squeegee meters the film. A flat one spreads and pushes. Knowing which job you are doing picks the blade.
· 3 min read

Notched vs flat squeegee comes down to one question: what controls the film thickness? With a notched squeegee, the notches do. With a flat squeegee, you and the roller do.
Use a notched squeegee when the film thickness matters
Most body coats and many primers and topcoats come with a wet film thickness (WFT) on the data sheet. A notched squeegee meters that film for you: pour, pull through with the blade flat, and the notches leave the right amount behind no matter how hard you push. Then back roll to even out the notch lines, using spiked shoes if you need to walk back into the wet coat.
Grimaldi notched squeegees run from 5 to 7 mils up to 50 to 60 mils. A 15 to 20 mil squeegee suits a standard body coat; an 8 to 12 mil suits thinner primers, base coats and many topcoats. To work out how much material that film takes, see epoxy coverage by mil thickness.
Use a flat flexible squeegee to spread fast over an uneven slab
The flat flexible squeegee has a smooth EPDM blade with no notches. It bends to follow small dips and changes in the slab, spreads coating quickly and pushes puddles and excess material toward thinner areas.
It does not set the film thickness. The final film is left to your technique and the roller, so use it where the data sheet does not call for a metered film, or where you will back roll to the finish.
Use a flat stiff squeegee for heavy material
The flat stiff squeegee is for heavier material that needs more push. The stiffer blade moves thick product across the floor without folding under the load.
18 or 24 inch?
Every Grimaldi squeegee comes in two widths:
18": easier to control in smaller rooms, around obstacles and along walls. For example the 18" flat flexible or 18" flat stiff.
24": covers open floor faster with fewer passes.
Many crews carry both: 24" for the field of the floor, 18" for edges and tight spots.
Before you start: handle, pole and data sheet
All Grimaldi squeegees have a one piece polymer frame and a threaded adapter. The handle is not included, so bring a threaded pole (see extension poles).
Check the coating's data sheet for the wet film thickness and any tool guidance.
Follow the coating's safety data sheet, keep the area ventilated and wear chemical resistant gloves and eye protection.
Quick pick: which squeegee for which coat
Body coat with a mil rating: notched, in the data sheet range
Thin primer or topcoat with a mil rating: notched, 5 to 7 or 8 to 12 mils
Spreading quickly over an uneven slab, then rolling: flat flexible
Heavy, thick material that needs push: flat stiff
Doing a garage flake floor? See the full flake floor tool checklist.
For the full order of work with a notched blade, see laying an epoxy body coat with a notched squeegee.
Questions contractors ask
Can I use a flat squeegee for an epoxy body coat?
Only where the data sheet does not call for a metered film, or where you will back roll to the finish. A flat blade does not set the film thickness.
Which notched squeegee for a thin primer?
A 5 to 7 mil or 8 to 12 mil notched squeegee, matched to the wet film thickness on the data sheet.
Does the squeegee come with a handle?
No. Grimaldi squeegees have a threaded adapter and the handle is not included, so bring a threaded pole.








